Icom 7300/9700

[M6XCC]

I'm using Icom 9700 and 7300. On the original MMSSTV, it's possible under the radio command tab to enter strings to turn the radio into digital mode, send the picture and return to non digital mode after tx ends. Is there any way to do this in YONIQ? I can see the strings needed in the INI file for omnirig, but can't see how to insert them in YONIQ.

[EA1IMW]

I'm using Icom 9700 and 7300. On the original MMSSTV, it's possible under the radio command tab to enter strings to turn the radio into digital mode, send the picture and return to non digital mode after tx ends. Is there any way to do this in YONIQ? I can see the strings needed in the INI file for omnirig, but can't see how to insert them in YONIQ.

You just have to activate the Omni-Rig option and configure it from the Option->Setup MMSSTV->TX section.

[M6XCC]

I'm using Icom 9700 and 7300. On the original MMSSTV, it's possible under the radio command tab to enter strings to turn the radio into digital mode, send the picture and return to non digital mode after tx ends. Is there any way to do this in YONIQ? I can see the strings needed in the INI file for omnirig, but can't see how to insert them in YONIQ.

You just have to activate the Omni-Rig option and configure it from the Option->Setup MMSSTV->TX section.

I've done this and it will TX, but it just flips the PTT, doesn't put it in FM-D. In the old MMSSTV, in the RadioCommand tab, you could enter the command strings to change the radio to FM-D, transmit, then turn back to normal FM. The command strings appear to be in the OmniRig ini file, but I can't see how you select the FM-D command in Yoniq. It just puts the radio in TX, I have to change to FM-D manually. I don't see the point in using OmniRig in Yoniq, if you can't actually use any of the functionality.

[EA1IMW]

I'm using Icom 9700 and 7300. On the original MMSSTV, it's possible under the radio command tab to enter strings to turn the radio into digital mode, send the picture and return to non digital mode after tx ends. Is there any way to do this in YONIQ? I can see the strings needed in the INI file for omnirig, but can't see how to insert them in YONIQ.

You just have to activate the Omni-Rig option and configure it from the Option->Setup MMSSTV->TX section.

I've done this and it will TX, but it just flips the PTT, doesn't put it in FM-D. In the old MMSSTV, in the RadioCommand tab, you could enter the command strings to change the radio to FM-D, transmit, then turn back to normal FM. The command strings appear to be in the OmniRig ini file, but I can't see how you select the FM-D command in Yoniq. It just puts the radio in TX, I have to change to FM-D manually. I don't see the point in using OmniRig in Yoniq, if you can't actually use any of the functionality.

You can try this http://foros.radiogalena.es/showthread.php?tid=465 to see if at least 7300 works correctly. The thing is, ICOM is a bit demanding.